The tension that the truss rod puts on the neck can only remove relief. Note: If you feel you need this adjustment to be made and you're not comfortable with the procedure, take your bass to your authorized Service Center.Ĭlick to expand."A question though, how can he use a 1 inch block to gain relief when the truss rod "It's completely" loose."? The pitch of the neck on your bass has been preset at the factory and in most cases will not need to be adjusted. Retighten the neck screws when the adjustment is complete. Tighten the hex screw with an 1/8" hex wrench approximately 1/4 turn to raise the action approximately 1/32". For those basses with the Micro-Tilt adjustment, loosen the two neck screws on both sides of the adjustment access hole on the neckplate by at least 4 full turns. 010" thick will raise the action approximately 1/32". A shim approximately 1/4" wide x 1 3/4" long x. To properly shim a neck, the neck needs to be removed from the neck pocket of the body. The need to adjust the pitch (raising the butt-end of the neck in the pocket, thereby pitching the neck back) of the neck occurs in situations where the string height is high and the action adjustment is as low as the adjustment will allow. It replaces the need for a shim by using a hex screw against a plate installed in the butt-end of the neck. On a few basses, a Micro-Tilt® adjustment is offered. A shim is placed in the neck pocket, underneath the butt-end of the neck. Shimming is a procedure used to adjust the pitch of the neck in relation to the body.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |